Step 2 Creating the design
- The Design Page appears on the screen as shown below.
- Area a
Embroidering area when the multi-position hoop is installed at the top installation position. - Area b
Embroidering area when the multi-position hoop is installed at the middle installation position. - Area c
Embroidering area when the multi-position hoop is installed at the bottom installation position.
The dotted lines separate each area.
- Area a
- Create the design, making sure that it meets the following conditions.
- The size of one pattern must be no larger than 100 × 100 mm (or 130 × 180 mm).
- Each pattern must completely fit within a single area (a, b, or c).
1: The position of this pattern is correct since it fits completely within area a.
2: The position of this pattern is correct since it fits completely within either area b or area c.
3: The size of this pattern is acceptable, but its position must be corrected since it does not fit completely within any of the areas.
(It will be necessary to correct the position in order to fit in either b or c.)4: This pattern must be corrected since it is too large.
(It will be necessary to correct the position and size in order to fit in either a, b, or c.)