Step 2 Creating a decorative fill pattern
- Click the [Home] tab.
- Click [Draw Line] in the [Tools] group.
- Click points (1) through (4), in order.
- To remove the last point that was entered, click the right mouse button.
- The grid spacing can be changed.
- Double-click point (5) (end point).
- Enter all necessary points.
- In order to create patterns that will be cleanly sewn without feeds between them, keep the following in mind.
- Make sure that all lines in the pattern connect.
- Make sure that patterns can connect at the top and bottom as well as at the left and right.
- Make sure that there are points at the top, bottom, left and right where patterns can connect.
- Use the [Preview] pane to check that patterns are connecting at the top, bottom, left and right.
- Use the guidelines to easily align the locations of points on the top, bottom, left and right edges.
- The editing procedures for Decorative fill mode are the same as in Fill/Stamp mode. However, region settings cannot be specified.
- In order to create patterns that will be cleanly sewn without feeds between them, keep the following in mind.