Using the Compact Digital Dual Feed Foot

The compact digital dual feed foot enables you to have best fabric control when sewing difficult fabrics that slip easily, such as quilted fabrics or fabrics that tend to stick to the bottom of a presser foot, such as vinyl, leather or synthetic leather.

Attaching the Compact Digital Dual Feed Foot

1. Touch . Remove the presser foot. (Replacing the Presser Foot)

2. Loosen the screw of the presser foot holder to remove the presser foot holder.

   
   1. Multi-purpose screwdriver
   2. Presser foot holder screw
   3. Presser foot holder

3. Position the compact digital dual feed foot to the presser foot bar by aligning the notch of the compact digital dual feed foot to the screw.

   

4. Hold the compact digital dual feed foot in place with your right hand, then using the included multi-purpose screwdriver, securely tighten the screw.

   
   CAUTION

   • Use the included screwdriver to firmly tighten the screw. If the screw is loose, the needle may strike the presser foot and possibly cause injury.

5. Plug the connector of the compact digital dual feed foot into the jack on the back of your machine.

   

6. Touch to unlock all keys and buttons.

7. Place the fabric under the compact digital dual feed foot with the needle at the starting point of the stitching.

8. Be sure that the feed position lever is pushed down and the compact digital dual feed foot is ready to sew.

   
   1. Feed position lever
      • Do not operate the lever while sewing.
      • When the feed position lever is up, digital dual feed function is not effective. When the feed position lever is down, the black roller belt on the compact digital dual feed foot is engaged.

Attaching/Detaching Sole

Attach the sole by aligning the pins with the notches and snap it into place.

1. Pins
2. Notches

   To detach, push down on the front and back part of the sole, the sole will snap off.

Adjusting the Amount of Fabric Feeding by the Compact Digital Dual Feed Foot

The digital dual feed mechanism pulls the top fabric according to the set stitch length. With troublesome fabrics, fine tune the set length.

1. Touch to display [Dual Feed Feed Adjustment] of the settings screen.

2. Touch the number to select the feeding of the top fabric.

   Select [00] for sewing in most cases.

   Touch a higher number to increase the feed amount for the top fabric.
   Touch a lower number to decrease the feed amount for the top fabric.