If the Bobbin Runs out of Thread

When the bobbin begins to run out of thread during embroidering, the machine will stop and the message below will appear.

1. Leave the message displayed and then press (Reinforcement stitch button) to sew reinforcement stitches to prevent stitches from unraveling.

2. Touch .

   • If the message appears when only a few more stitches are necessary to complete embroidering, simply press the “Start/Stop” button, allowing about 10 more stitches to be embroidered.
   • If [Upper and Bobbin Thread Sensor] in the settings screen is set to off, the message shown above does not appear.
   • Touch [Return] to close the message.

3. Touch [OK].

   
   • After the thread is automatically cut, the carriage will move.

4. Leave the message displayed and then continue with the next step.

   

5. Unlock the frame-securing lever and remove the embroidery frame.

   Be careful not to apply strong force to the fabric at this time. Otherwise, the fabric may loosen in the embroidery frame.

   

6. Insert a wound bobbin into the machine. (Refer to Setting the Bobbin.)

   

7. Attach the embroidery frame.

8. Touch [OK].

   • The carriage will move to its previous position.

9. Press (Reinforcement stitch button) to sew reinforcement stitches at the beginning of sewing, and then press the “Start/Stop” button to continue embroidering.