Using the Cord Guide Bobbin Cover

1. Remove the bobbin cover from the machine.

   Installing the Bobbin

2. Thread the gimp thread through the hole in the cord guide bobbin cover from bottom to top. Position the thread in the notch at the back of the cord guide bobbin cover.

   
   1. Notch
   2. Gimp thread

3. Snap the cord guide bobbin cover into place, making sure that the gimp thread can be fed freely.

   • Make sure there are no restrictions when feeding the thread.
   

4. Set the zigzag width from 2.0-2.5 mm (approx. 1/16 - 3/32 inch).

5. Attach the monogramming foot “N”.

6. Position the fabric right side up on top of the cord and place the cord to the rear of the machine under the presser foot.

   
   1. Fabric (right side)
   2. Gimp thread

7. Lower the presser foot and start sewing to make a decorative finish.