Using Overcasting Foot “G”

1. Select from the stitches below.

   

2. Attach overcasting foot “G”.

   
   CAUTION

   When using overcasting foot “G”, be sure select a stitch that can be used with overcasting foot “G”. If you sew with the incorrect stitch, the needle may strike the presser foot and break, and may cause injury.

3. Position the fabric with the edge of the fabric against the guide of the presser foot, and then lower the presser foot lever.

   
   1. Guide

4. Rotate the handwheel toward you (counterclockwise). Check that the needle does not touch the presser foot.

   
   1. The needle should not touch the center bar

5. Sew with the edge of the fabric against the presser foot guide.

   
   1. Needle drop point
   IMPORTANT

   • Be sure to pull the fabric backward after finished sewing. If you pull the fabric toward side or forward, the presser foot pin may be damaged.
   • If thread is tangled on the presser foot, remove the entangled thread, and then raise the presser foot lever to remove the presser foot. If the presser foot is raised while entangled with thread, the presser foot may be damaged.

6. Press the “Start/Stop” button to stop sewing when you have reached the end of the stitching, and raise the presser foot and needle to pull the fabric under the presser foot towards the back of the machine.