Attaching Embroidery Foot

CAUTION

• When attaching an embroidery foot, always touch on the screen. You may accidentally press the “Start/Stop” button and possibly cause injury.
• Be sure to use the embroidery foot “UH” or embroidery foot “UH+” with LED pointer when doing embroidery. Using another embroidery foot may cause the needle to strike the embroidery foot, causing the needle to break and possibly causing injury.

1. Remove the presser foot and presser foot holder.

   Removing/Attaching the Presser Foot Holder

2. Position the embroidery foot “UH+” with LED pointer on the presser foot bar by aligning the notch of the presser foot to the presser foot holder screw.

   

3. Hold the embroidery foot in place with your right hand, and then use the disc-shaped screwdriver to securely tighten the presser foot holder screw.

   
   1. Presser foot holder screw
   CAUTION

   Use the disc-shaped screwdriver to firmly tighten the presser foot holder screw. If the screw is loose, the needle may strike the embroidery foot and break, possibly cause injury.

4. Plug the connector of the embroidery foot “UH+” with LED pointer into the jack on the back left side of your machine.

   

5. Touch to unlock all keys and buttons.

   • All keys and operation buttons are unlocked, and the previous screen is displayed.